1. 用户应准备好加压气体及管路、驱动气体及管路、高压气体出口管路，根据增压泵出厂时提供的说明书固定增压泵，并根据增压泵进出口接头的尺寸连接管路；检查耐压是否足够，接头是否漏水等。检查完好后，即可进行加压试验。

1. Users should prepare pressurized gas and pipelines, drive gas and pipelines, high-pressure gas outlet pipelines, fix the booster pump according to the instructions provided at the factory, and connect pipelines according to the size of the inlet and outlet joints of the booster pump; Check if the pressure resistance is sufficient and if the joint is leaking water. After inspection, the pressure test can be carried out.

2. 气源：气体增压泵驱动气源的压力范围一般为1.8-8bar，不建议其驱动气源超过10bar。如果驱动气源过高，会对泵体造成很大程度的损坏，甚至对操作人员造成伤害。

2. Gas source: The pressure range of the driving gas source for the gas booster pump is generally 1.8-8 bar, and it is not recommended that the driving gas source exceed 10 bar. If the driving air source is too high, it will cause significant damage to the pump body and even harm the operators.

3. 气体增压泵选型：客户要根据自己的压力需求选择相应的增压比，并根据自己的压力需求突出气源压力、入口压力、输出压力需求和流量，让技术人员更准确的帮您选型。

3. Gas booster pump selection: Customers should choose the corresponding boost ratio based on their pressure requirements, and highlight the gas source pressure, inlet pressure, output pressure requirements, and flow rate according to their pressure requirements, so that technical personnel can more accurately help you choose.

4. 对于现场使用环境：现场使用环境必须干净，不能有太大的尘粒，驱动气源和加压介质的含水量不能太高，否则会大大降低泵的使用寿命。

4. For on-site use environment: The on-site use environment must be clean, without too large dust particles, and the water content of the driving gas source and pressure medium should not be too high, otherwise it will greatly reduce the service life of the pump.

5. 对管道的要求：客户现场使用时，必须检查高压输出管道的密封性，使用的管道、阀门、压力表必须大于气体增压泵输出的额定压力，以确保人员安全。

5. Requirements for pipelines: When customers use them on site, the sealing of the high-pressure output pipeline must be checked. The pipelines, valves, and pressure gauges used must be greater than the rated pressure output by the gas booster pump to ensure personnel safety.

6. 对压力容器的要求：所有承压部件，尤其是压力容器，必须有压力容器制造厂出具的压力容器检验报告。

6. Requirements for pressure vessels: All pressure components, especially pressure vessels, must have a pressure vessel inspection report issued by the pressure vessel manufacturer.

开云app下载的关于气体增压泵的问题或者详细的内容，请进入我们公司的网站： http://www.sdjingtuo.com网站中会有很多的内容仅供参考。

For more questions or detailed information about gas booster pumps, please visit our company's website: http://www.sdjingtuo.com There will be a lot of content on the website for reference only.